Ring Sizing 
We require a specific ring size with your order before we can commence manufacture. ClanTime takes no responsibility for incorrect ordering of ring size. Please view our ring size chart below to help determine correct ring size or visit your jeweller to ensure you have your correct size.
We guarantee the size of the ring supplied is correct according to the order. On receiving your Saltire Ring, if you find the ring doesn't fit your finger you can have the ring resized. Due to the complexity of the face of the 'Heirloom' & 'Dress' rings, we recommend any alterations be carried out by our jewellers. Should you have your ring resized by a professional jeweller, ClanTime assumes no responsibility.
In general a wider ring may need to be slightly larger, and a narrow ring may need to be slightly smaller. Bear in mind that the Saltire Gents Ring is relatively wide.
To find your ring size:
-
Simply measure the distance around your finger with something flexible such as a strip of paper or a piece of string.
-
Wrap the paper or string around your finger at the thickest point and use a pen to mark the beginning and end points.
-
Use a ruler to measure the distance between the 2 points.
-
Find the nearest measurement on the chart below and that is approximately your ring size.
When in doubt between 2 sizes, it is always safer to go to the next larger ring size.
|
|
Aus/UK |
Euro |
USA/Can |
Inner Circumference (inches) |
Inner Circumference (mm) |
|
Wheatsheaf |
Size No |
Size No | |||
|
Average Ladies |
L |
11 |
5 3/4 |
2.007 |
51 |
|
M |
12 |
6 1/4 |
2.066 |
52.5 | |
|
N |
14 |
6 3/4 |
2.126 |
54 | |
|
O |
15 |
7 1/4 |
2.165 |
55 | |
|
P |
16 |
7 3/4 |
2.205 |
56 | |
|
Ladies & Mens |
Q |
17 |
8 1/4 |
2.264 |
57.5 |
|
R |
19 |
8 3/4 |
2.323 |
59 | |
|
S |
20 |
9 1/4 |
2.362 |
60 | |
|
T |
21 |
9 3/4 |
2.421 |
61.5 | |
|
U |
23 |
10 1/4 |
2.480 |
63 | |
|
Large Mens (and thumbs) |
V |
24 |
10 3/4 |
2.519 |
64 |
|
W |
25 |
11 1/4 |
2.559 |
65 | |
|
X |
26 |
11 3/4 |
2.618 |
66.5 | |
|
Y |
28 |
12 1/4 |
2.677 |
68 | |
|
Z |
29 |
12 1/2 |
2.716 |
69 |
Finger Shapes
A typical or medium finger shape is one where the knuckle joint is slightly larger than the fleshy part above it where the ring is worn. In this case, the ring should be a close fit over the knuckle, but feel comfortable to wear once it is in place.
Well-built fingers owners will find that the fleshy part of their finger is larger than the knuckle joint. In this case, obviously the ring will slide over the knuckle easily, but there is a slight danger that the ring could slip off. To avoid this, it is better if the ring fits slightly more tightly on the flesh than for people with "medium" fingers. It may be worth a short period of slight discomfort with a new ring to ensure a snug fit ever after, as the flesh under the ring will usually adjust slightly to the ring.
Points to Note
-
The best size is usually the ring that fits snugly and gives a little resistance when you take it off. Wider rings should be a little looser than narrow rings.
-
Fingers are a bit larger in warm weather and smaller in cold weather, so take that into account.
-
Men take note that if you are not used to wearing a ring, the proper size will probably feel tight at first. Many men lose their wedding rings because they choose sizes that are too loose.
Ready to Order?
If you are ready to place an order for your very own exquisite Saltire Ring, please go to our Products page. If you have any further questions regarding the order process, or wish to learn more about the Saltire Ring, please don’t hesitate to contact us.
